Standalone: Re-connecting Your Hive Thermostat Mini to the Receiver

Remove the Thermostat from the Wall:

• Press the tab underneath the thermostat to remove it from the wall.
• Take out one battery.

Move to the Receiver:

• Take your thermostat to the receiver, usually located near the boiler or hot water tank. 

Power Cycle the Boiler:

• Turn off your boiler using the mains isolation switch (the lights will go out).
• Turn it back on (the lights will come on).

Activate Pairing Mode on the Receiver:

• Press and hold the central heating button (bottom right) on your receiver until the status light (top right) changes to single flashing pink.
• If it flashes orange, release and press again until it changes to a single flashing pink.

Reset the Thermostat:

• Reinsert the battery into your thermostat.
• Press and hold the down arrow and circle keys (bottom left and middle) until the screen shows ‘factory reset’ and counts down from 10 to 0. 
• Release the buttons when ‘welcome’ appears. The thermostat will then display ‘searching’ with a timer.

Repeat if Necessary:

• If anything else appears on the thermostat screen, repeat step 5.

Wait for the Thermostat to Connect:

• The thermostat will now search for the receiver.
• When found, the receiver’s status light (top right) will turn solid green, and the thermostat should display the normal screen.

Test the Boiler:

• Raise the target temperature above the room temperature on the thermostat to test your boiler.