Skip to content
Self Service

Performing a Full Network Restart for Your Nano2 Hub

Created on Tue Dec 03 08:22:44 UTC 2024 | Last modified on Tue Dec 03 08:24:05 UTC 2024

  • Back
  • PDF
  • Print
  • Share
    • Facebook
  • Copy To Clipboard
  • Collapse All Expand All

Action

Follow the steps below to perform a full network restart:

  1. Unplug the Hub: Unplug the hub from the mains power supply. The light on the hub should go out.
  2. Disconnect the Ethernet Cable: Disconnect the Ethernet cable that connects the hub to your broadband router. Make sure to disconnect both ends.
  3. Switch Off Your Broadband Router: Turn off your broadband router at the mains power supply.
  4. Switch On Your Broadband Router: Turn your broadband router back on at the mains power supply.
  5. Ensure Broadband is Working: Before proceeding, ensure your broadband connection is working.  TIP: Check another device, such as your mobile phone, to confirm you have a broadband connection. 
  6. Reconnect the Ethernet Cable: Reconnect the Ethernet cable between the router and the hub. Ensure it is plugged into a yellow port on the back of your broadband router.
  7. Plug the Hub Back In: Plug the hub back into the power supply. The light on the hub should now be illuminated.
  8. Wait for the Hub to Reconnect: Wait for 30 minutes. The hub should flash and then display a solid green light. If you refresh your app or log out and back in, you should see the Nano2 Hub back online under "Manage Devices."

Next Steps

Has a Full Network Restart Resolved your issue?

Audit History

Add notes here if prompted.